Raider Pro 250 (single-seat / double-seat): Service Manual EEC Version: 1.0 Oct.. 2004
29
d. Turn the fuel adjusting screw left and right slightly;
e. Repeat steps c, d;
f. Adjust the throttle adjusting screw to the idle speed position
(1,500+/-100rpm);
g. Run the engine from low speed to high speed;
Run the engine at the idle speed for 10~ 15 seconds to see if the
idle speed is stable;
h. If the idle speed changes, repeat steps c~f.
3.8.9 Inspection of Air Cleaner
a. Check if the air cleaner is damaged;
b. Replace it with a new one if necessary;
c. Clean the air cleaner every 1,000 km. of running;
d. Replace the air cleaner every 5,000km,of running.
3.8.10 Ignition Timing
Adjustment of Ignition Timing
The C.D.I. is used, so there is no need to adjust the ignition
timing. If the ignition timing isn’t normal, check the C.D.I. and AC
generator.
Inspection of Ignition Timing
a. Turn on the ignition timing lamp;
b. Align the mark “F” within the range of +/-3º at the rotation of
1,700rpm;
Ignition Timing: B.T.D.C 13º+/-3 1700rpm.
C. If the rotation is above 3,000rpm, the aligning mark should be located
before the advanced ignition mark.
3.8.11 Adjustment of Valve Clearance
a. Check and adjust the valve clearance when the engine has become
cold;
b. Turn the drive pulley in the left crankcase in the left direction;
c. Align the mark on the cam sprocket with the cylinder head cover;
at this time, the piston is at T.D.C. (compression top dead point);
d. Adjust the valve clearance to the standard value (0.06-0.08mm) with
special tools;
e. Fasten the lifter nut.
Summary of Contents for Raider Pro 250 S
Page 1: ......
