(4)
MCA-09
© 2009 Dayton Audio
®
Warranty Information
Dayton Audio® products are constructed by industry experts, and are thoroughly tested before shipment. Dayton Audio®
products are warranted for the period of one year. This warranty is limited to manufacturer defects, either in materials or
workmanship. Dayton Audio® is not responsible for any consequential on inconsequential damage to any other unit or
component or the cost for installation or extraction of any component of the audio system. In the rare case of a product
failure, please contact your place of purchase or call our Customer Support Department at (937) 743-8248.
Warranty Limitations
There are no other warranties, either express or implied, which extend the foregoing, and there are no warranties of
merchantability or fitness for any particular purpose. The warranty will not cover incidental or consequential damage due to
defective or improper use of products. This includes but is not limited to burnt voice coils, overheating, bent frames, holes in
the cone, or broken lead wires.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
Non-Warranty Service: If non-warranty service is required, the product may be sent to the Company for repair/replacement,
transportation prepaid, by calling (937) 743-8248 for details, complete instructions, and service fee charges.
Specifications
High Frequency Section
Speaker Impedance: 8 ohm
Power Output:
35W RMS @ 8ohm
Frequency response: 2.2KHz-20KHz
THD:
Less than 0.05% @ rated power
S/N Ratio:
Greater than 83dB at rated power
Low Frequency Section
Speaker Impedance: 8 ohm
Power Output:
45W RMS @ 8ohm
Frequency response: 15Hz-5.2KHz
THD:
Less than 0.05% @ rated power
S/N Ratio:
Greater than 83dB at rated power
Bass Boost:
3dB from 20Hz ~ 200Hz
General
Crossover Slope:
24dB / octave low pass and high pass filters
Crossover Points
2.2KHz, 3.2KHz, 3.8KHz, 4.5KHz, 5.2KHz,
Input sensitivity:
1000mV p-p
Power Requirements: 115AC, 60Hz or 230V, 50Hz
Power Stand-By:
0.7W consumption
Overall Dimensions: 8 5/8" (H) x 5 3/8" (W) x 4-1/2" (D)
Required Opening:
7 3/4" (H) x 4 5/8" (W), 3-1/4" (D)
All manuals and user guides at all-guides.com
