background image

3

5. Wiring Your Subwoofer

Once you have you have installed your subwoofer you are ready to connect it to your amplifier. Strip the 

wire outer jackets back about 2" and strip each conductor back about ¼" to bare copper. See connec

-

tion diagram below, locate the 4-conductor input cable and connect the left and right channels from your 

amplifier. Locate the 2-conductor left and right speaker output cables, connect your satellite speakers to 

these cables. 

6. Caring For Your Subwoofer

Outdoor speakers and subwoofers are designed to withstand outdoor environments, including incidental 

exposure to water. They are not designed to be washed using a pressure washer or hose nozzle. If debris 

accumulates on the housing of the speaker, use a damp sponge or cloth to remove it.

7. Troubleshooting

Should your subwoofer not work properly, check the following:

No sound from speakers or quiet/strange sound:

•  Make certain you observed proper polarity for both inputs and outs on the subwoofer. Check the 

connections at the back of the amplifier, and then at the subwoofer

•  Most stereo receivers have an A/B speaker selector switch. Make certain that this switch is in the 

proper position, and that the proper audio source is selected.

•  Mute feature or protection mode is activated. Check for short circuits in speaker wiring.

One speaker is playing while the other is not playing or plays quietly:

•  Check the balance control on the receiver. Make sure it is centered.

•  Loose connection at either the receiver or the speaker. Double check connections.

•  Bad speaker cable. Replace suspect speaker cable.

Receiver cuts on and off:

•  This could be caused by a short circuit between the positive and negative leads. Check the con

-

nections at the back of the receiver, and then at the speaker; make sure that no strands of wire 

from one connector is touching the other connector

Reviews: