3
INSTALLATION NOTES
Mounting Locations
HOME –
0RXQWLQJWKH%DVV6KDNHUWRFKDLUVRUFRXFKHVWKDWDUHQRW¿[HGWRWKH
ÀRRUZLOOSURYLGHWKHJUHDWHVWHIIHFWV7KHHQHUJ\RIWKH%DVV6KDNHUZLOOLPSDFWWKH
XVHU¶VERG\UDWKHUWKDQWUDYHOWKURXJKWKHIXUQLWXUHDQGGLVSHUVHWKHHQHUJ\LQWRWKH
ÀRRU,VRODWLQJWKHIXUQLWXUHIURPWKHÀRRULVKLJKO\UHFRPPHQGHGE\XVLQJSDGVRU
rubber feet. Find a solid mounting area for your Bass Shaker(s) underneath and/or
RQWKHUHDURIWKHIXUQLWXUH¶VFRQVWUXFWLRQ8VHIRXUZRRGVFUHZVRUVWLQJHUVWRPRXQW
the Bass Shaker to the structure. Should no solid mount exist it is recommended
that one be constructed using hardwood or plywood. Try to avoid fabric or padding
coming into contact with the Bass Shaker. It is important the Bass Shaker come in
IXOOFRQWDFWZLWKDVROLGÀDWVXUIDFH
Recommended wire gauge is 14-16 Gauge
6SHDNHU:LUH
AUTO –
Mounting the Bass Shaker under the seats is highly recommended rather
than on the seat itself. Move (or remove) your seat forward as far as possible, and
LGHQWLI\WKHVSRWXQGHUWKHVHDWWKDWYLEUDWHVWKHPRVWE\NQRFNLQJRQWKHÀRRULQJ
using a rubber mallet or soft hammer. Again, ensuring the Bass Shaker comes into
IXOOFRQWDFWZLWKWKHÀRRUVXUIDFHLVFULWLFDOWRWKHSHUIRUPDQFHRIWKH%DVV6KDNHU
Wiring in advance of the installation is recommended. Ensure your wire is without
kinks or bends and that no bare wire is touching metal. Use four steel screws or
VWLQJHUVWRPRXQWWKH%DVV6KDNHUWRWKHÀRRURI\RXUYHKLFOH
Recommended wire
JDXJHLV*DXJH6SHDNHU:LUH
WARNING:
Always check under carpeted locations and recheck the mounting area
so as to not cut or drill into any existing electrical wiring, airbag sensors, hydraulics,
brakes, gas, or fuel lines.
ADDITIONAL NOTES AND SUGGESTIONS:
• Add a Low Pass 4 Ohm Crossover at a suggested 80Hz to reduce the possibility
of high frequency sounds
5HFRPPHQGHG$PSOL¿HUV'D\WRQ$XGLR6$IRUVLQJOH%DVV6KDNHUV'D\WRQ
Audio SPA250 for 2 – 4 Bass Shaker installations. For larger installations we
recommend the Dayton Audio SPA1000 or SA1000.
