Daytona P200T, User Manual

Page: 50 / 60

Chapter 4 - Technical Specification
4.1.6 Table requirements
WARNING
Do
NOT
plug the scan head into a power block or powered table. The scan head must be
plugged directly into a wall socket.
The scan head should be positioned in the middle of the table width. The front of the scan
head should be inline with the front of the table to allow the patient to get into the correct
alignment position.
The scan head and touch screen must be positioned on a table that meets the necessary safety standards.
The table
MUST
support the weight of the scan head.
TABLE 10: Table size requirements
Dimension Details
Width 887 mm (35 inches) (not including wheel position)
Depth 623 mm (24.5 inches) (not including wheel position)
Height 725 mm to 1205 mm (29 inches to 47 inches)
Where wheelchair accessibility is required the table must meet wheelchair accessibility standards.
4.1.7 Battery
CAUTION
Do
NOT
remove the scan head covers. Only Optos trained technical personnel are
permitted to service the device.
The device contains a 3V Lithium coin battery.
4.1.8 Environmental considerations (ambient)
Do
NOT
operate the device in an environment that exceeds the environmental limits, see Warnings and
cautions on page 11.
TABLE 11: Environmental ranges
Status Temperature
Relative Humidity
(Non-condensing)
Atmospheric Pressure
Normal use +10°C to +35°C 30% to 75% 700hPa to 1060hPa
Storage -10°C to +60°C 10% to 95% 700hPa to 1060hPa
Transport -10°C to +60°C 10% to 95% 500hPa to 1060hPa
Note
Device is DEHP free.
4.2 Laser safety designation (IEC 60825-1)
CAUTION
All P200T product variants are Class 1 laser devices at the eye, and comply with IEC/EN
60825-1:2007 and 21 CFR1040.10 and 1040.11 except for deviation pursuant to Laser
Notice 50, dated June 24, 2007.
Based on current scientific knowledge, a Class 1 laser device can be considered as safe
by engineering design, and safe under reasonably foreseeable conditions of operation.
Page 50 of 60
English
Part Number:
G102748/11_ENG
Copyright
2021
, Optos plc. All rights reserved.