Days Verb Power Chair
User Manual
- 8 -
Adjustment Procedures
Footrest Adjustments
Length
Using the hexagon key provided, remove the screw, nut
and bush on the footrest outer tube.
Slide the footrest inner tube up or down to the required
height and secure in place with the screw and nut,
ensuring the bush is in the larger hole in tube work and
clamped in place underneath the nut.
Note - The height adjustment screw must always be fitted through one of the
holes in the body of plastic support moulding.
Seat Belt
Hold the bayonet end in one hand, and pull on the webbing to increase or
decrease belt length with the other. When length is correct, adjust slide buckle to
suit.
- 17 -
CAUTION! -
•
The charger is for indoor use only
•
Do not use an open flame whilst batteries are being charged
•
Do not use the battery charger if it has been dropped or misused as damage to
the electronics could occur
•
Do not leave the charger plugged in the mains supply and switched-off. Al-
ways remove the plug
Battery Gauge
The battery gauge works in the following way:
Located on the control box, the battery gauge has three colour bars:
When you switch on the control system, the battery gauge shows an estimate of
the remaining battery charge.
If the battery shows red, yellow and green, the batteries are charged.
If the battery shows just red and yellow, then you should charge the batteries as
soon as you can.
If the battery gauge shows just red, either steady or flashing slowly, then you
should charge the batteries immediately.
At full charge all eight lights will be on. As the battery charge drops during
Powerchair operation successive bars will extinguish. Except in emergency, do
not drive on discharged batteries. If you ignore the warning (the bottom bars
flashing) and the battery charge drops further to a level where there is no longer
sufficient charge to allow safe driving, the controller will automatically cut the
power supply to the motors and the power chair will come to abrupt stop.
