background image

Days Healthcare Escape Wheelchair 
User Manual 

When both wheels have been secured, grasp both side frames of the wheelchair 

and pull apart as far as possible or at least until there is sufficient room to push 

down on the sides of the seat canvas. 
The chair is fully open when the seat canvas is taut and flat. 
Place the seat cushion on top of the canvas with the angled edge towards the front 

of the chair. Note that Velcro holds this in place. 

!

"

!

#

$

%

The rear wheels are removed by depressing the rubber cover at the centre of the 

wheel hub and withdrawing the wheel. 

!

#

$

%

The 

Escape

 wheelchair model 388 is fitted with quick 

release rear wheels. It is important to ensure that wheels are 

correctly fitted to avoid accidents. 
To fit rear wheels depress rubber cover at the centre  of the 

wheel hub and push the wheel spindle firmly into the axle 

bush, ensuring that both ball bearings are fully exposed 

beyond the axle bush. 
Once located, test the wheel for security by pulling the wheel firmly in an attempt 

to remove it without depressing the rubber cover. 

 

&

'

To move forwards or backwards, the user should release the brakes, grasp the 

handrims (attached to rear wheels) and with a pushing action rotate them 

forwards or pull them backwards respectively. 
To move to the right, hold the right handrim steady and push forward with the 

left handrim. To move to the left, hold the left handrim steady and push forward 

the right handrim. 

- 10 - 

(

When using indoors beware of narrow doors, steps, high surfaces, protruding 

wall fittings and everyday household items such as children’s toys, electrical ap-

pliances etc. Take extra care in kitchen environments. 
To ensure stability and safe control you must maintain proper balance at all 

times. The wheelchair is designed to remain stable during normal use as long as 

you do not move you centre of gravity outside the normal seating position. 
When reaching/bending forward do not lean your body out of the wheelchair further 

than the length of the armrests. Do not attempt to reach objects by sliding forwards to 

the edge of the seat. 
When reaching/bending backwards do not reach any further than your arm will ex-

tend without changing your seating position. 
Never attempt to use an escalator or stairway, always use a lift. 
Occasionally check that the adjustments of the footrests, armrests and controller 

are secure and are set in the most comfortable position for use. 
 
 
 
 
 

 

- 7 - 

Summary of Contents for 388 Escape SE









Reviews: