3
2. WARNINGS AND SYMBOLS
WARNING
The pump must not be installed against wood or any
other material which may be affected by heat from
the pump.
WARNING
B e f o r e i n s t a l l i n g t h e p u m p e n s u r e a l l
soldering/welding adjacent to the pump is complete,
the system has been thoroughly flushed out to remove
any foreign matter and that vent and feed pipes are
positioned so that the pump will not draw in air or
over pump.
WARNING
It is advisable to ensure the impeller is free by
rotating manually through the outlet.
WARNING
The pump should not be installed in either a high
point in the system where air can collect or a low point
where sediments could build up.
WARNING
Pipes on both sides of the pump should be supported
to reduce strain and must be correctly aligned prior to
installing the pump to reduce the risk of scalding.
WARNING
The pump must be installed with the rotating shaft
horizontal.
WARNING
Check the direction of flow indicated by an arrow on
the pump casing and install the pump between the
isolating valves. When replacing a pump maintain
the same direction of flow.
WARNING
Use approved makes of additives with corrosion
i n h i b i t o r s o n l y a n d f o l l o w m a n u f a c t u r e r ’ s
instructions. Do not leave system empty without
protection from corrosion inhibitor.
WARNING
No non-approved replacement parts may be used.
