16
1.
SYMPTOM: THE SPA WILL NOT OPERATE
a. Check the power cord. The power cord must
be plugged into a grounded outlet (see PLUG-
GING IN THE DAYBREAK on page 12).
b. Check to see if the GFCI breaker is tripped, or
was not turned on. Reset the GFCI breaker.
2.
SYMPTOM: THE CIRCUIT BREAKER OR GFCI
BREAKER TRIPS WHILE THE SPA IS
OPERATING
a. Reset the circuit breaker. If the circuit breaker
trips again, contact a qualified electrician for
service.
3.
SYMPTOM: THE PUMP HUMS
a. The filter may be dirty or damaged. Remove
the filter housing from the spa jet unit and clean
or replace the filter.
b. The pump may have a foreign object stuck in
the impeller. Contact our customer service
department or a local spa and pool service
provider.
c. The pump may have a loose wire connection.
Contact our customer service department or a
local spa and pool service provider.
4.
SYMPTOM: THE PUMP HUMS BUT DOES NOT
ROTATE
a. The pump may be jammed. Contact our cus-
tomer service department or a local spa and
pool service provider.
5.
SYMPTOM: THE PUMP IS NOISY WHILE
OPERATING
a. There may be debris in the pump. Contact our
customer service department or a local spa and
pool service provider.
b. The pump may have a bad bearing. Contact
our customer service department or a local spa
and pool service provider.
6.
SYMPTOM: THE WATER DOES NOT HEAT
a. The pump in the spa jet unit is the heater. If the
pump is operating, the water should heat.
Cover the DAYBREAK with the spa cover.
The
spa cover must be tight.
Set the air control to
low. The water will heat at a rate of 1.5¡F an
hour. If you are using the DAYBREAK indoors,
and the room temperature is maintained at
70¡F, it will take approximately 36 to 48 hours
for the water to reach the set temperature.
b. If you are using the DAYBREAK outdoors, it
may take longer for the water to heat. See the
chart below for the approximate heating time.
Air Temperature
Heating Time
70¡F +
36 to 48 hours
50¡FÐ70¡F
2 to 4 days
30¡FÐ50¡F
4 to 6 days
b.
If the water still has not heated after six days,
contact our customer service department or a
local spa and pool service provider.
7.
SYMPTOM: THE WATER PULSATES OR
THERE IS MINIMUM WATER FLOW
a. Adjust the water level. This usually occurs only
when the water level is low. Add water until the
filter and jets are covered.
8.
SYMPTOM: THE SPA JET UNIT CAVITATES
DURING USE
a. This problem is caused by excess air in the
pump circulation system. Check to see if the
primer cap is fully tightened. Prime the pump
again and fully tighten the primer cap (see
PRIMING THE SPA JET UNIT on page 12).
9.
SYMPTOM: THE WATER IS NOT BEING
CLEANED BY THE FILTER
a. Check to see if the filter is in place. Clean the
filter if it is dirty.
b. Check the chemical balance of the water. If the
pH is incorrect, the sanitizing agents will not
function properly.
TROUBLE-SHOOTING
Most problems can be solved by following the simple steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at
1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time.
