DAXOM UKDAX-10EBM, Manual

Page: 12 / 48

The electrical installation must be carried out by a qualified
electrician using suitable diameter cable determined according
to the boiler capacity and cable length. The MCB and RCD
with appropriate characteristics and amperage which can cut
the boiler electricity completely should be located separately
and be close to the device. If there is no earthing installation in
the structure where the boiler is installed, the grounding line for
the boiler should be installed by a qualified electrician. The
Isolator switch must be located near the boiler, and after the
Isolator switch there must be enough cable to connect to the
boiler. The connection of the cables to the boiler must be done
by a qualified installer. Cable diameters calculated according to
boiler capacity and cable lengths, and MCB and RCD
amperage values can be seen in the table below.
Model
Pow
er
(kW)
Phase &
Voltage
(V)
Current
(A)
Fuse &
Residual
Current Device
(A)
Cable
Section
(mm)
UKDAX-10EBT 10 3~400 3*15,2 3*20 5*2,5
UKDAX-12EBT 12 3~400 3*18,2 3*20 5*2,5
UKDAX-16EBT 16 3~400 3*24,3 3*25 5*4
UKDAX-18EBT 18 3~400 3*27,3 3*32 5*4
UKDAX-20EBT 20 3~400 3*30,4 3*40 5*6
UKDAX-24EBT 24 3~400 3*36,4 3*50 5*6
UKDAX-6EBM 6 1~220 27,3 32 3*4
UKDAX-10EBM 10 1~220 45,6 50 3*6
UKDAX-12EBM 12 1~220 54,6 63 3*10
UKDAX-16EBM 16 1~220 72,8 80 3*16
UKDAX-18EBM 18 1~220 81,9 100 3*16
12