Installation
How to wash
*
*
*
Sort the clothes into groups-white, colorfast, non-colorfast, delicates, lint free, lint producer, etc., and
wash according to the
LAUNDRY GUIDE.
(See Laundry Guide).
Clothes with worn or torn patches should first be mended. Empty out all pockets and close all side
fasteners. (pocket, covers, belts, etc). Treat bad stains prior to washing.
Insert power cord plug into the power point and switch on.
1. Set the wash timer knob to position “0”.
2. Select the wash action to the desired position.
3. Open the water faucet and feed water to the water level indicated inside the wash tub.
4. Put detergent and laundry into the wash tub.
5. Set wash time by the wash timer.
Location & Environment
Electrical Connection
*
*
*
*
Do not place the washer in steamy rooms or where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation and cause an electric shock hazard.
Place washer on a sturdy flat surface. If the washer is placed on an uneven or weak surface, noise or
vibrations may occur. (Allowable inclination is max. 2 degrees).
Avoid direct sunlight or heating device. As plastic and electrical components are affected by direct
heat. Never place the washer near heater, boilers etc...
Do not place or store the washer below 0
O
C(32
O
F) to avoid any damage from freezing.
*
This unit is designed to operate from an adequate supply mentioned at the rating label sticked to the rear
of it.
Caution:
If the power cord is damaged, it should be replaced by a repair shop appointed by the
manufacturer, because special purpose tools are required.
Preparation
How to wash
03
04
How to rinse
Laundry guide
Cleaning and maintenance
1. Set the wash action to the desired position.
2. Turn the water tap on.
3. When the rinsing water becomes clear, turns off the water tap.
Washing Time & Wash Action Table
Extremely soiled heavy fabric
Linen, cotton, etc.
Ordinary clothes (underwear, etc.)
Slightly soiled synthetic fiber
100% wool, mixed wool knitting, thin synthetic
fiber with tags indicating hand washing
10-15 minutes
8-10 minutes
7 minutes
2-5 minutes
2-5 minutes
KIND OF CLOTHING
WASHING TIME
At the end of every washing:
Switch off the electricity.
Ensure that timer knob reached back to “0” position.
Wipe off spillage (detergent powder, etc.) and generally wipe over the tub and base with a dry duster.
Step I Remove the overflow filter by pulling it
forward.
Step II Wash off the lint stuck on the overflow filter
during overflowing.
Step III Re-fix the overflow filter by first inserting
its bottom section and then pushing the upper
part firmly into the socket.
Note:
Cleaning after use will extend the life of your washing machine. Before cleaning
disconnect the power cord from the electrical outlet.
Lint filter
Note:
If during washing, some residue or deposits have accumulated in the net, then after
finish washing, remove the filter by first push down and pull it out.
