Cleaning of dirt underneath Pulsator & on Drain Strainer
Dirt, lint etc. may accumulate underneath the pulsator and on a Drain Strainer. Carry out cleaning after
every four to six washes or whenever required, as per following procedure.
Step I After finishing the wash, fill the wash tub upto three quarters with clean lukewarm water.
Step II Set wash action to “STRONG” position.
Step III Operate washer for 10 minutes.
Step IV Drain out the water.
Note:
The above procedure will remove the dirt, lint etc. accumulated underneath the pulsator
and on the drain strainer.
Cautions
Do not connect to the hot water supply.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliances by a person responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
This product should not be disposed with other household wasters. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources.
To return your used device, please use the return and collection system or contact the retailer where the product was
purchased. They can take this product for environment safe.
POINTS TO REMEMBER
Avoid using excessive amounts of bleach, soap powder of detergent. Use the amount recommended
by the respective manufacturers.
If the machine is installed in areas subject to freeze, ensure that it is completely drained after use.
When washing delicate, clothes e.g., silks, fine nylons, laces etc., it is advisable to place them
in a mesh bag to prevent them from possible damage.
Do not wash lint attracting fabrics with lint producers, e.g., black socks or dark colored
jumpers with white fluffy towels, napkins, etc.
Avoid placing a wet load on the control panel.
Do not move machine in left or right direction because wheels are undirectional.
04
