9 / 14 EN
Cooker Hood / User Manual
3.1 Wall drilling and bracket
fixing
3.1.1 Wall mounting
•
Draw a vertical line on the at the center of the
wall.
•
From bench top (see A), drawing a horizontal line
(see B) above minimum installation height level.
•
Mark a reference point at C, Repeat this step on
the other side.
•
Drill ø 8mm holes at center of marking points.
Insert wall plug in the wall.
•
Fix the hood body to wall using 2 (ST5 x 25)
screw, tighten the screw firmly.
Note:
Adjust the hood body alignment if neces-
sary.
•
Place mounting bracket on the wall at desired
height level, aligning bracket center at vertical
line (see D).
3
Installing your appliance
•
Mark the center of the bracket holes and drill ø
8 mm holes. Insert wall plug in the wall. Secure
mounting bracket firmly using 2 (ST5 x 25)
screws.
•
Fix the inner duct to both mounting bracket
using 2 (M3x 12) screws.
•
Slide the outer duct downwards and ensure that
it is well seated on the hood body.
3.2 Aligning the hood body
•
Before attaching the hood body, adjust the two
screws located on the hood body mounting
points.
•
Hook the hood body onto the support screws
and tighten the support screws fully.
•
Adjust screws to level the hood body.
