DAVIS Universal Shelter, User Manual

Page: 4 / 8

2
Install the console, IP Gateway or Envoy in
the shelter
Note: You may mount the shelter before installing the device. However, it may be easier to do
this at a workbench rather than in the field.
The shelter has been designed to fit Davis consoles. Inside the shelter, outlines of
the Vantage Pro2 console, Vantage Vue console, and Envoy will indicate where
they will be mounted in the shelter.
1. Before mounting a Vantage Vue console, remove the kickstand. Before
mounting a Vantage Pro2 console or Envoy, point the antenna down.
2. The holes to use for mounting your console or Envoy are marked: VP2 for
Vantage Pro2 console, VV for Vantage Vue console, and E for Envoy. For IP
Gateway, use top Vantage Pro2 hole.
3. Screw the two (one for IP Gateway) 1/2” pan head screws into the correct
holes. The depth of the hole has been specifically designed so that the screw
will “bottom out” at the correct depth.
Note: You may need to adjust the screw height for proper fit.
4. Using the keyhole(s) on the back of the console, Envoy, or IP Gateway, slide
the device onto the screws and move it down to lock into position.(Note: use
just one screw for IP Gateway.)
5. Close and lock the shelter.
Outline and screw holes for
mounting a Vantage Vue Console.
Outline and screw holes for
mounting a Weather Envoy
Outline and screw holes for
mounting a Vantage Pro2 Console.
E
E
VV VV
VP VP
ENVOY Vantage
VUE Vantage
PRO2
Outline and screw holes for
mounting an EnviroMonitor IP Gateway
E
E
VV VV
VP VP
ENVOY Vantage
VUE Vantage
PRO2
E
E
VV VV
VP VP
ENVOY Vantage
VUE Vantage
PRO2
E
E
VV VV
VP VP
ENVOY Vantage
VUE Vantage
PRO2