Vantage Pro Version: Installation on the Sensor Mounting Shelf
Page 13
Securing the Sensor on the Shelf
1. Remove the rain collector cone: turn it
counter-clockwise until the latches
allow you to lift it up and off.
2. Place the shield onto the body as
shown.
3. Route the sensor cable down through
one of the large holes in the mounting
shelf.
4. Place a flat washer over the end
of each screw and insert it into
the body.
5. Place a spring over the end of
each screw and hold the springs
in place using a #6 screw
retainer.
6. Secure the sensor to the mount-
ing shelf by driving the screws
into the appropriate holes as
shown.
7. Using the bubble level on the sen-
sor as a guide, adjust the sensor
until it is level by tightening or
loosening the screws as neces-
sary.
Note:
Final leveling of the sensor(s) should be done with the ISS mounted in its operating location.