Now that the tool is reassembled you can reinstall the Positioner Body and Positioner
After reassembly, cycle the crimp tool manually to confirm function. The tool should articulate
freely, the ratchets should engage and disengage smoothly, and the the crimp depth selector
should function as before.
NOTE:
if the crimp tool is sticky, articulates poorly, requires excessive pressure to close or
sticks in position a piece of debris may have gotten caught om the cams or springs --
disassemble and clean tool again with careful attention to debris which may be caught in
the Indenters, the cams or the Indenter springs. If this occurs the tool must be
disassembled, cleaned and lubricated again.
After confirming good function, re-install tool into your CDSS Automated wire termination
machine and resume crimping.
