Page 2
Grounding Kit
C
ONNECTING
THE
R
OD
The rod itself ships in two pieces. You must connect them to create a suitably
long grounding rod. Be aware, however, that pounding the top of the rod may
make it impossible to fit the coupler (or the wire clamp) over the top of the rod.
Make sure you put the coupler (and wire clamp) onto the rod before you begin
pounding.
Connect the two halves of the rod, using the provided coupler, as
shown below. Note that the bottom of the assembled rod (the end which goes
into the ground) should have a point and the top of the assembled rod should
be flat.
C
ONNECTING
THE
R
OD
