12
Driver ID Code
When using the DriveRight 600 to monitor the driving of multiple
drivers, assign each driver a unique 4-digit ID code. Before driving
the vehicle, the driver must enter his or her ID code. The DriveRight
600 stores the driver ID code with the rest of the trip information,
which enables you to view information for each individual driver.
In addition, data downloaded by the software is segregated by
driver ID code, enabling detailed tracking of multiple drivers.
The DriveRight Vehicle Management Software allows you to use the
driver ID code to track locations instead when a single driver is
using a vehicle. You may also use the software to turn on an alarm
which will alert the driver when a driver ID (or location ID) has not
been entered.
NOTE:
Driver ID code 0000 (four zeros) is used to view information for
the vehicle (all drivers) and should not be assigned to any
driver, unless only a single driver uses the vehicle.
In addition to marking data as belonging to a particular driver, the
driver ID code may be used when viewing information on the dis-
play to filter the information being viewed. To view information for
one specific driver, enter that driver’s ID code in this screen. The
DriveRight 600 display will filter out any data not assigned that
code.
To view all information, regardless of driver ID code, enter the
reserved code: 0000.
You have the following options from the Driver ID Code Entry
Screen:
❏
Enter a Driver ID Code
The flashing digit in the code is the active digit. Press and
release PLUS or MINUS to cycle forward or backward
through the available entries for the active digit (0 to 9). To
change the digit which is active, press and release SET/
CLEAR. Each time you press SET/CLEAR, the next digit
become active.
If you have loaded driver ID codes into the DriveRight 600, then
only those codes will be accepted. A “no” will apear on the
screen if a wrong ID code is entered. A code of “0” will still be
accepted.
DR600 UG Rev B D008.fm Page 12 Thursday, April 17, 2003 7:17 AM
