Davin J012, Service Manual

Page: 78 / 365

1. Loosen the knob screws (x2) of the ADF connector [1] and disconnect it.
2. Raise the ADF [2] while tilting it slightly toward the back of the machine to disengage the feet of the
ADF.
3. Raise the feet out of the holes and remove the ADF.
Original Pressure Plate
1. Remove the platen or ADF (see above).
• To avoid damaging the mylars or the exposure glass, remove the platen or ADF before removing
the original pressure plate.
2. Set the platen or ADF on a flat surface.
3. Use the tip of a flat-head screw driver to release tabs [1] and [2].
4. Release tabs [3] and [4].
5. Pull the plate to the left and lift it out (the tabs on the left should disconnect easily).
Reinstallation
Common Procedures
77
3