Davin J012, Service Manual

Page: 188 / 365

6. [Yes]
ENG SW1 00001001
Bit0 _
7. Set Bit1 to "1"
• [

] to move the cursor to Bit1 (2nd position from right)> [Yes]
• [  ] to toggle the setting to "1"> [Yes].
ENG SW1 00001011
Bit0 _
8. [No] 3 times > [  ] or [  ] > "End" > [Yes] > Machine switches off.
9. [Power] to switch the machine on.
10. Pull the release under the operation panel forward and raise the scanner unit.
11. Confirm that the envelope selector is forward.
12. [Menu]> "System Settings?"
13. [
 ] or [  ] > "Maintenance" > [Yes]> "1 Nozzle Check?"
14. [

] or [

] > "2 Head-flushing>" > [Yes]> "All Heads"
15. [  ] or [  ] > Select the print heads to be flushed: "All" (all print heads), "Print-head 1" (Black/Cyan),
"Print-head 2" (Magenta/Yellow") > [Yes]
"*Please Wait*" displays until flushing is finished. Do not start any other operation until cleaning stops.
16. [No] [No]> Standby
• The print head is flushed while the piezo element is rapidly switched on and off.
• Once this operation is completed, Bit 1 resets to "0" automatically.
• If you need to do this procedure again for another print head, you must repeat this procedure
and set Bit 1 to "1" again in the SP mode.
• Drive cleaning cannot be performed if the ink tank of the selected print head is almost empty.
Cleaning the Printheads Before Storage
Do this procedure to clean the print heads before storing the machine for one month or longer.
• This procedure should be done at the Repair Center before storing a machine until it can be reused.
This procedure is not intended for use at the job site by the customer.
Image Correction
187
4