0750
Mast Light With Cast Transformer Box
12V
Installation Diagram
IP54
DP0750/AL/AN Anodised Aluminium
DP0750/AL/SD/AN Sandblasted Aluminium, Anodised
DP0750/GM/PO Polished Bronze
DP0750/GM/SD Sandblasted Bronze
DP0750/GM/SD/WE Sandblasted Bronze, Weathered
Contents
1 - Small Top Screw
2 - Mast Light Body
3 - GX5.3 Lampholder
4 - Mast Light Door
5 - Door Screw
6 - Connector
7 - Mast Light Body
8 - Earth Wire
9 - Long Bottom Screw
10 - Transformer Box
11 - M4 Nut
12 - WAGO
13 - IP44 Box
14 - Screw (x4)
15 - Brass Box
16 - Rawl Plug (x4)
Required for Installation
-
Screwdriver, flat-head
- Small screwdriver, flat-head
- Drill (if holes are required)
Fixing Instructions
- Open light by unscrewing the mast light door screws.
- Remove the brass box from the casting to access fixing pack.
- Feed the lampholder wires and the earth wire though the castings.
- Follow the wiring instructions overleaf (see 8) to wire the fitting.
- Drill a hole though the brass box to feed the mains cable though.
- Fix the light to the wall using the fixing screws.
Apply a bead of silicone between the transformer box and the wall if installing the light in a damp or exterior
location to protect against possible damage caused by moisture ingress. We advise that this fitting is only
installed by a suitably qualified person.
A
B
C
D
E
Fixing Screw
GX5.3 Lampholder
Mast Light Body
Earth Wire
WAGO
F
G
H
I
J
Mains Supply*
Transformer Box
Connector
Transformer
IP44 Box
K
L
Brass Box
Rawl Plug
Key
GX5.3
MR16
LAMP GUIDANCE
TYPE*
WATTAGE**
BASE
SHAPE
HALOGEN
LED
35W aluminium coated/20W Dichroic MAX
6W
* Warm white (2700k) low energy lamps recommended.
** Wattage value provided as a guide to suitable lamps. Lower wattage than stated may be used.
*Not Supplied
5
2
1
4
3
6
9
10
11
7
13
15
8
14
16
12
CABLE
GRIP
TOP COVER
L
N
brown
blue
red or brown
black or blue
Transformer
Mains
A
B
C
G H
I
J
K
L
D
E
F
ENSURE
SLACK
INSIDE
FITTING