NOTE:
All systems will consist of one starter rail assembly and the required amount of add-on rail
assemblies. Example: A B632LT consists of (1) #36LTBSST; starter and (2) 36LTBSAO; add-on
(Part numbers are found on each box.) The starter rail assembly contains one section of rail and
hardware. The add-on rail assembly contains one section of rail, hardware and one mobile carriage.
All mobile carriages are preset at the factory to include 2" of overtravel. Systems up to a 4/3
configuration for Bi/Tri/Quad do not require overtravel. Overtravel can be increased or decreased as
needed, please refer to the diagram below for more information.
STEP 3:
Install 12 leveling glides per rail section making sure that each one is screwed in and flush
with the bottom of the rail assembly.
STEP 4:
Position stationary connector channels on the front bottom of each stationary base. Attach
each connector channel using a minimum of (4) #8 x 3/8" tek screws
(See figure 2, detail A)
.
STEP 5:
Join rail assemblies together using (4) 1/4-20 X 3/4" bolts and flange nuts. Rail sections will
have corresponding holes for attaching side to side
(See figure 2, detail B2)
. Position rail assembly
on floor, do not attach to connector channel at this time.
STEP 6:
Attach the deck end cap to the rail section starting from the left end of the rail assembly
using (2) 1/4"-20 X 3/4" bolts and flange nuts
(See figure 2; details B1, B3)
. Repeat procedure for
right side of system.
STEP 6A:
FOR TRI/QUAD SLIDER SYSTEMS ONLY.
Position additional row(s) of rail sections in
front of Bi-Slider rail sections described above. Attach deck end cap to Bi-Slider and Tri-Slider track
assembly using (4) 1/4-20 X 3/4" bolts and flange nuts. Repeat procedure for right side of system.
STEP 7:
Attach the assembled rail section to the connector channel. The rail assembly will have
corresponding slots which will secure to the connector channel.
(See figure 2)
.
Standard Placement Of Wheel Assembly
For 2" Overtravel (Center Holes). No Need
To Adjust For Systems Up To A 7/6
Bi/Tri/Quad Configuration.
Placement Of Wheel Assembly For No
Overtravel (Outside Holes). Adjustable If
Necessary Up To A 4/3 Bi/Tri/Quad
Configuration.
Placement Of Wheel Assembly For 4"
Overtravel (Inside Holes). For Systems
Greater Than 7/6 Configurations.
Typical Bi/Tri Slider Mobile Carriage
Proper Placement Of Carriage Wheels For Overtravel
6
American Filing Solutions P.O. Box 891719, Temecula, CA 92589 Toll Free: (888) 891-1970 x 8958 Fax: (888) 891-9970 Email: [email protected] www.FilingToday.com
