a. Activate the 'settings'-mode by rotating the mechanical key clockwise about 15-20 degrees for about 3 seconds.
Applying pressure until the blue indicator lights on， then releasing after 1 beep， the fingerprint scanner is ready.
b. Press the finger at the center of the fingerprint area. If the data is collected successfully the blue indicator
will flash once and a beep will sound to notify that one input is acquired. If there is a faulty input or any
failure， the red indicator will flash once and "tick" two times to signal invalid input.
c. Repeat step 'b' until 5 successful scans is acquired. A total of 5 scans is needed for any single fingerprint.
d. After the final scan， a long beep will sound to indicate the successful fingerprint-profile acquisition.
Note: a) 5 correct scans are required to enter a fingerprint.
b) When adding a fingerprint， please spread out the fingerprint area scanned to get a comprehensive
fingerprint profile.
c) Please try to paste the fingerprint on the whole sensor area when scanning.
d) If any given fingerprint can open the door after fingerprint setting， which means the fingerprint record
failed， please refer to the instruction book to do fingerprint record again.
1 Adding fingerprints
Lock settings
8
Hold for 3 seconds
Summary of Contents for L-B200
Page 1: ...User manual E S ...
