EN
Dateq XTC Manual
Connections
7
Connections
MASTER L / R
Electronically balanced master outputs for the left and right channel on
XLR connectors. This type of output guarantees a perfect signal transport
even when long audiocables are being used. These outputs are equipped
with relays to prevent ‘plopping’ of connected equipment while switching
the XTC on or off.
OUT
Unbalanced master output on cinch-connectors. Can be used to connect
the XTC to an amplifier or a recorder.
SUB
Unbalanced low-frequency output on jack connector. On this output only
signal with a frequency lower than 125 Hz. Extra amplifiers for low-
speakers can be connected here.
MON
Unbalanced monitor output on cinch connectors. Can be used to connect a
second amplifier with monitor speakers for the DJ or a second room.
X / T / C INPUT
Cinch connectors for the 3 channels with faders. Each channel has an
input for turntables (Phono) and equipment like CD-players, samplers,
keyboards and recorders (Line). When turntables are being used, these
must be earthed by means of the earth-clamp.
REMOTE
On all channels an optional remote start connector can be delivered. As
soon as the fader of the concerning channel is opened, the contact
between tip and ring of this mini jack (3,5 mm) connection is made. With
this the connected equipment can be remote started. The remote-
connection is NOT suitable for switching mains voltage!
DJ MIC
Electronically balanced microphone input on XLR connector. When used
unbalanced, connect pen 1 and 3 with the shielding of the cable.
PHONES
Extra stereo headphone connection on a standard 6,3 mm TRS jack. The
signal on this connector is the same as on the headphone-connection on
the front of the XTC.
Power
Powerswitch. With this switch the XTC is switched on and off..
FUSE
Mains fuse. Dimension 5x20mm (small), 315mA fast.
MAINS
Mains cable. Before connecting the XTC for the fist time, see if your XTC is
meant for the mains voltage in your country (label on the connector board
at the rear).
For all cinch-connectors:
White = Left, Red = Right.
Summary of Contents for XTC
Page 1: ...XTC XTC XTC XTC USER MANUAL ...
Page 2: ......
