EN
Dateq ONYX Manual
Operation
9
Master section (A and B)
The Onyx has two identical master sections (A and B). Each section consists of
a triple tone control, balance control, volume control and a monitoring function
(after-fader listening).
HIGH
High tone adjust.
MID
Middle tone adjust.
LOW
Low tone adjust.
BAL
Determines the balance between the left and the right
channel. When in mid-position, the left and right channel can
be heard evenly loud.
MASTER
Volume control for both the unbalanced stereo output (A and
B) and the balanced stereo output (Master A only).
Cue
Switches the monitoring function on and off. When this button
is pressed the signal of this master is audible on the
headphones and visible on the LED VU meter.
Miscellaneous
POWER
Mains voltage switch of the Onyx.
MIC FRONT
An extra microphone can be connected quickly to this
connector. The signal can be adjusted using channel 1.
PHONES
Volume control for the headphones.
TALKOVER
When this button is pressed the talkover function is
activated. As soon as a signal comes in on channel 1 (and
channel 1 is routed to output A and/or B using the A and B
switches), the volume of channels 2-6 will be attenuated.
When this happens the LED next to the talkover switch will
light up red. When the talk-over function is activated the LED
will light up green.
PHONES
Stereo headphones output. The selected Cue signal is
always present at this output.
Meter
This is an easy-to-read 2- x 12-segment LED display of the
Cue signal. An operating level of approximately 0dB is
nominal.
Summary of Contents for Onyx
Page 1: ...ONYX USER MANUAL ...
