Dateq CREW, User Manual

Page: 7 / 12

6 Dateq Crew Manual Connections En
Mic/ Mic Front/ Mic Rear balanced inputs (XLR 3-pins female)
Pin Function Type
1 Ground A-GND
2 Audio + In
3 Audio - In
Phones output (TRS Jack 3p, front)
Pin Function Type
Tip Left Out
Ring Right Out
Sleeve Ground A-GND
Connections
BALANCED
MASTER L/ R (A) Electronically balanced master outputs on XLR connectors for the left and
right channels of master A. This type of output guarantees perfect signal
transmission even if long audio cables are being used. These outputs are
equipped with relays to prevent connected equipment from ‘plopping’ when
the unit is being switched on and off.
MASTER A/ B Unbalanced outputs on cinch connectors. These can be used to connect
the Crew to an amplifier or recorder. These outputs are equipped with relays
to prevent connected equipment from ‘plopping’ when the unit is being
switched on and off.
ZONE 1...4 Audio out With these outputs additional zones with separate external volume control
can be created. These outputs can be used to connect external amplifiers.
ZONE 1...4 Volume This input controls the volume of the additional zone. Between the tip and
the shield a potentiometer or an external control voltage can be supplied.
See page 7 for a more detailed explanation.
CHANNEL 7...3 Cinch connectors for the stereo line inputs. Each channel has two identical
inputs (line 1 and line 2) for CD-players, keyboards, MD-players etc. With
the input-selector on the front on of the two inputs can be activated. Each
input has it’s own gain-trimmer at the rear.
CHANNEL 2 Combined mono mic/ stereo line channel with an electronically balanced
microphone input on a XLR-connector and a stereo line input on a cinch
connector. When using an unbalanced microphone pin 1 and pin 3 must be
connected to the shielding of the cable.
CHANNEL 1 This channel has two electronically balanced microphone inputs on XLR-
connectors (Mic Front and Mic Rear). When using an unbalanced
microphone pin 1 and pin 3 must be connected to the shielding of the cable.
MAINS/ FUSE Euro mains-input. The Crew operates at 230V/ 50Hz. Fuse: 5x20mm
(small), 315mA slow.
For all audio cinch connectors:
White = Left, Red = Right