16
TLM-170HM: Fitting the monitor to a 19” Rack
The TLM-170HM is designed to rack mount. When folded away it is 1U high, please bear in mind that
when opened for operation the monitor is
7
U high, so leave adequate room above for this.
The monitor arrives already fitted with sliding rack rails, these have a length adjustment at the rear to
suit the distance between the front and rear rack rails of your cabinet.
To adjust the length loosen the four adjustment nuts as illustrated below, and pull the side rails back
as far as is required. Then re-tighten the nuts.
Mount the monitor in your rack with the rear panel facing upwards. Ensure the rack mounting screws
are secured both front and rear.
Once mounted and secure to the rack, unscrew the two locking screws on either side of the front
panel, and pull the monitor forward using the handle. Once the monitor is fully forward simply hinge it
up into a vertical position.
To fold away, pull the top of the monitor forward, so that it hinges down to a horizontal position, then
push it back into the rack until you are able to screw in the locking screws.
N.B.
When folding the monitor away be careful not to trap your fingers or scrape your hand on the
rack cabinet.
