Datavideo PTC-280NDI, Instruction Manual

Page: 12 / 132

12
3
4K HDMI OUT
The 4K HDMI OUT allows you to connect an external HDMI monitor via
an HDMI cable.
4
3G-SDI OUT
The 3G-SDI OUT allows you to connect an external monitor via an SDI
cable.
5
MIC IN/LINE IN
The 3.5mm audio input receives external audio.
6
RS-422 Interface (RJ-45)
The RS-422 interface serves to connect external RS-422 devices. Use an
Ethernet cable to connect external RS-422 controllers. See
“Section 16
Remote Control Port Pinouts” for making the cable for the RS-422
interface.
Note: If users want to switch between the RS-422 and DVIP
communication protocols, please use the No.4 pin of the DIP Switch
which is located at the bottom of the PTC-280NDI. Please switch this
pin to “ON” for operating in DVIP mode. If this pin is switched to
“OFF”, it will operate in “RS-422” mode.
7
IRID Interface
This interface allows users to use the DVIP Switch to control the
numbering of the camera on the remote controller. Users can use this
interface to set the camera to any number from No.1 to No. 4 in order
to use remote controller to control the camera.
8
NDI® | HX & DVIP Interface
NDI® | HX interface allows users to connect the PTC-280NDI and a PC to
the RJ-45 Ethernet interfaces of the same router by using an RJ-45
Ethernet cable. Moreover, users can set the PC and the PTC-280NDI
camera in the same local area network for controlling some functions of
the PTC-280NDI camera by NewTek’s “NDI Studio Monitor” software.
The most important benefit that the NDI brings to users is that it allows
the output screen of the PTC-280NDI camera to be auto-recognized by
the NDI compatible receiving devices (e.g. Notebook PC) which are set
in the same local area network.