InstallatIon and operatIon 8
•
do not insert a metallic object or inflammable object into any opening of the product.
•
only use the screws and brackets (as supplied in the rack kit) for mounting in a 19-inch rack.
•
Unplug this product from the aC power supply before cleaning. do not use liquid or aerosol clean-
ers on the product. Use a microfiber cloth for cleaning.
•
after storage in cold conditions, let the product adapt to normal temperature for two hours before
powering on.
VENTILATION
airflow is critical for the correct operation of WatCHpaX 40.
there are four built-in fans which maintain airflow and cooling during operation. air flows from the
front of the unit to the rear. Keep therefore both front and rear panels clear of obstruction at all times.
In an installation, there should be a minimum of 200 mm clear space at front and 200 mm at back of
the unit.
INSTALLATION
GENERAL
•
this equipment is for professional use for installation at locations where only adults are normally
present. Check the
•
the WatCHoUt 40 must be connected to a properly grounded wall socket (a socket-outlet with
protective earth connection in the building).
•
the serial number is located on the base of the unit.
IMportant: only use the power cord supplied with the WatCHpaX 40 unit, otherwise dataton aB
cannot guarantee full functionality.
Air inlet: do not block.
Keep a minimum 200 mm clear space at front of unit
Air outlet: do not block.
Keep a minimum 200 mm clear space at rear of unit
