SE-S
SERIES
Floor stand
The floor stand of the SE-S series can be used for the installation of both the emitter
and receiver units of the
SAFE
asy
TM
safety light curtains series, as well as for the SE-
DM deviating mirrors series.
Five versions with different lengths are available in order to satisfy all application needs.
In particular the support post lengths available are given below:
800, 1.000, 1.200, 1.500, 1.800 mm.
Moreover protective stands of the SE-P series are available. These have to be mounted
on the support post using two M6 x 10 screws, and relative washers and square nuts.
The different lengths of the protective stands have been calculated to suit each safety
light curtain model.
ISTRUCTIONS FOR USE
Mount the three angle brackets
(A)
on the post using the nine M6 x 10 screws
(B)
,
relative washers and square nuts inserting the latter in the side slot of the floor support
post (refer to the figure). Do not tighten the screws in order to allow the angle brackets
to move along the post.
Position the assembled part on the plate
(C)
and fix the angle brackets using the six M6
x 16 screws
(D)
and relative washers.
Tighten the fixing screws of the angle brackets to the post.
Before inserting the protection cap
(E)
on the top part of the post, the square nuts
necessary for the fixing of the emitting and receiving units or deviating mirrors have to
be inserted inside the front slot.
NOTE: For the correct safety device functioning, the floor stand has to be firmly
fixed to the ground using the four inserts given, ensuring that the post is
perpendicular to the ground.
The washers with an one-side opening (given in the package) can be used
to correct the post inclination respect to the ground, inserting them
between the support plate and the ground itself.
DIMENSIONS
856000380 Rev.00
A
A
A
C
B
C
D
E
Model
L (mm)
X (mm)
SE-S 800
800
30x30
SE-S 1000
1000
30x30
SE-S 1200
1200
30x30
SE-S 1500
1500
45x45
SE-S 1800
1800
45x45
