AP25 Installation and Operating Guide
Page 56
AP25 Installation & Operating Guide
Document # 9301H79500 Ver. 1.00
4.2.2.2
Update System Software from USB Device
You may update the software through a USB drive.
1.
First, obtain the software update file from Datasat Digital Entertainment technical
support.
2.
Copy the update file to the root directory of the USB drive. Be sure not to change the
filename, or the AP25 will not recognize it.
3.
Insert the USB drive into the USB slot on the front panel of the AP25, choose
Select
Update Source > USB (see
Figure 27), select the update file and press the
Start Update
button.
Note: If you select an older version of software than is currently loaded on the AP25, you will
receive a warning message and be asked to verify to continue.
4.2.3 Saving and Restoring Configuration Files
You can save and restore standard configurations and master configurations to a USB drive (memory
stick). You can also save Diagnostic information (the system log file) for use in troubleshooting the
system.
A
master configuration
is intended to be a template used to configure similar AP25s in a system. It is
used as the first step in creating the configuration of each installed unit. Copy the master configuration
file from one AP25 and load it via USB into all AP25s.
Note
: Always be careful, as any existing Master Configuration file on the USB will be
overwritten when you save another one.
The
standard configuration
is specific to one AP25. This contains the unique third octave EQ, DiracEQ,
formats, profile, automation, and global configurations needed for that AP25. The standard
configuration file can only be loaded back onto the same AP25.
You can also load a screensaver of your choice via the USB port.
To perform any of these options, insert the USB drive into the front panel and then press the
USB
Save/Restore
button on the System Setup screen. (If no Flash drive is present, a message will appear
prompting you to insert a USB device.)
