Dataprobe iBootBar iBB-N15, Installation And Operations

Page: 18 / 37

Page 18
iBootBar V1.5x
Device Commands
Command
Description
Admin
Fact Default
get devices / get all / get outlets This command displays a list of connected devices, and their current status. No
get device <#1 ‐ #16/devname> Get device information. Displays the device name, and all outlet names and current
status Yes Dataprobe
set device <#1 ‐ #16 > name <name> Set the name of the selected iBootBar. 20 characters max.
get current
Gets the measured current of the local iBootBar Yes
get device <#1 ‐ #16/devname> current Get the measured current of the selected iBootBar
get cycle
Get or set the cycle time in seconds. No 10
set cycle <1 ‐ 99>
get delay Get or set the delay time in seconds. No 1
set delay <1 ‐ 99>
get current alarm High and Low alarms are used to monitor current conditions and send an alert by
email, SNMP and syslog when the high or low thresholds are exceeded.
From 0.0 to 10.0/15.0/20.0 (depending on max current for device) in 0.1 amp
increments. For devices with two Mains, Main A and Main B are set separately, but
displayed together with the get command.
Yes Highalarm:
10.0 for 10 Amp
Models
15.0 for 15 Amp
Models
20.0 for 20 Amp
Models
Lowalarm:
0.0 Amp
get device <#1 ‐ #16/devname> current alarm
set main <a/b> highalarm <nn.n>
set device <#1 ‐ #16/devname> main <a/b>
highalarm <nn.n>
set main <a/b> highalarm <nn.n>
set device <#1 ‐ #16/devname> main <a/b>
lowalarm <nn.n>