Connections
The VisionRGB-E2/E2S card has two DVI-I type connectors for two separate, simultaneous inputs. The top
connector is referred to as Channel 1, the bottom connector, Channel 2.
•
Connect to the source using:
•
DVI-D Cable
•
DVI-A Cable
•
Analog VGA (RGB) cable (adapter supplied)
•
HDMI cable (adapter supplied)
•
Component HD cable (adapter supplied)
Connect one end of the cable to the source. Connect the other end of the cable to DVI-I type connector
located on the VisionRGB-E2/E2S card in your computer.
Installing Multiple Cards
Multiple cards can be installed in a system providing a large number of capture channels. Combinations of
Vision capture cards in the same machine are supported by the driver.
To control the order in which the driver uses the cards, it is recommended when installing multiple cards
that the J6 links on the VisionRGB-E2/E2S are configured. The illustration below shows the jumper link
settings for up to 32 cards in a single system. When two cards have the same link settings, their order is
determined by the PCI bus:
18
Indicates link fitted
Indicates Link not fitted