Ì
Loading Media
Ø
Rotate the
Printhead Latch
and raise the
printhead
Ø
Slide the Roll
Media onto the
Media Hub
Ø
Route the
Media as
shown
è
Internal Media Loading
Ø
Route the media through one of the external slots in the
printer and over the top of the Media Supply Hub.
Ø
With the Roller Lever in its down slide the Fan Fold
Media Guide onto the Media Supply Hub until it rests
against the inside edge of the slot in the Fan Fold Guide
and raise the Roller Lever to its up position.
Ø
Tighten the Thumbscrew on the bottom of the Fan Fold
Guide.
External Media
Loading
Í
Printer
Controls
Œ
Pause:
Toggles the pause condition.
•
Feed:
The FEED button feeds a
label, and clears any faults
that have been corrected.
Ž
Cancel:
Cancels a job and pauses the
printer.
•
Menu:
Toggles between the ready
and menu mode.
•
Test:
Enables the quick test mode,
see the Operators Manual
for additional information.
Œ
Arrow Up:
Moves to the next item in the
menu tree, (increase values).
•
Arrow Down:
Moves to the previous item in
the menu mode, (decrease
values).
Ž
Enter:
Selects a displayed item or
value.
•
ESC:
Moves to the previous menu
level.
Œ
Ready:
On indicates ready,
blinking indicates menu mode.
•
Stop:
On indicates paused state.
Ž
Error:
On indicates a fault. To clear a fault
press the feed button.
Î
Printing a Test
Label
With the Printer On, and loaded with media (at least 6 inches wide):
Ø
Verify the printer is in the ‘Ready Mode’
è
Ø
Press the
button.
Ø
Using the button scroll to ‘
Print Config Label’
. Press the
button again, after a brief hesitation the printer will print one
Configuration Label.
‘
Additional
Information
Refer to the Operator’s Manual for the Printhead Cam Adjustment when
using narrow media.
Be sure to follow and perform the suggested Cleaning Schedule listed in
the Operator’s Manual.
Contacting Datamax…
Corporate Headquarters
(407) 578-8007
Technical Support
(407) 523-5540
For the latest products, news, and support visit our web page at
www.datamaxcorp.com
