OC-2 SERIES OF PRINTERS USER'S GUIDE
4
Note: Do not force the battery into the battery cavity.
When inserted properly, the battery easily slides and locks
into place. If the battery does not easily slide into place,
re-insert the battery.
6. Close the printer cover (Figure 13).
7. Charge the battery (batteries are shipped uncharged). For
more information, see "Charging the battery" on page 4.
Removing the battery
1. Lift the battery up and out of the battery cavity while sliding
it to the left (Figure 14).
2. Remove the battery from the battery cavity (Figure 15).
Charging the battery
The battery status LED will glow red if the battery charge is
low and the printer is powered on. (For more information, see
"Using the control panel" on page 12.)
Charge the battery as follows:
1. Verify the battery is installed correctly.
Figure 13
Figure 11
Figure 12
Figure 14
Figure 15
Summary of Contents for OC-2 series
Page 2: ...OC 2 SERIES OF PRINTERS 110203 003 User Guide ...
Page 3: ......
Page 27: ...COPYRIGHT 2010 DATAMAX O NEIL ...
