PROGRAMMER’S REFERENCE MANUAL
Printer settings
Page 47
69 <n>
Vertical print position adjustment, in
1
/
10
mm. Shifts the print picture north
(positive values) or south (negative values). Valid values for n are all integer
values. Default is 0.
72 <n>
...
79 <n>
Font mapping of bitmap fonts. Maps a physical font number (the ordinal
number of the bitmap font in memory) to a logical font number used when
printing.
The physical font number is the parameter number minus 70. For example,
!Y75 3
maps physical font 5 (the 19-dot font) to logical font number 3. The
physical font 1 is always logical font 1.
Physical font
Font name
(1 7x9-dot
bold)
2
hv18r
3
15-dot
bold
4
9-dot
5
19-dot bold x 18
6
hc42c
7
g19 x 12
This option was used in Mk2 printers to emulate different font sets in Mk1
printers.
///Bitmap fonts are deprecated, but kept for backward compatibility!
89 <n>
Allow command character anywhere on the line. Valid values for n are {0, 1}
and they are interpreted as follows:
0 = Command character must be first on the line (default)
1 = Command character can be anywhere on the line
92 <n>
Stacked printers mode (daisy chaining). Used when sending commands to a
specific printer in a daisy chain. This requires the receiving COM port to be
set to ‘Printer’ mode and the transfering COM port to ‘Stacked printer’ mode.
See parameter 150 and 152. Valid values for n are {0, 1, …, 65535} where n is
the printer to be referenced.
See section ‘Communication modes’ for further information.
93 <n>
LTS auto repeat. If enabled, a new copy will be printed when current label is
removed, that is, the LTS will have the same functionality as the default
behaviour of the printkey. It is also possible to print a new printout when the
label is removed, that is, the LTS will have the same functionality as when
sending the command ‘!P’. Valid values for n are {0, 1, 2} and they are
interpreted as follows:
0 = auto repeat disabled (default)
1 = auto repeat enabled (copy of previous printout)
2 = auto repeat enabled (new printout)
Note that parameter 39 must be enabled for the LTS to work at all.
