Datalogic Touch 90 pro, Product Reference Manual

Page: 38 / 332

Enter/Exit Programming Mode ACK NAK Options
28 Touch TD1100
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
"ACK Character" on page 254
for more detailed programming instructions.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
"NAK Character" on page 255
for more detailed programming instructions.
NOTE
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
Data Bits
has been set
as 7 Data Bits.
$CR2AC
Select ACK Character Setting
DEFAULT
0x06 ‘ACK’ Character
NOTE
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
Data Bits
has been set
as 7 Data Bits.
$CR2NA
Select NAK Character Setting
DEFAULT
0x15 ‘NAK’ Character