SETUP
9
QUICKSCAN™ I QD2200
CONFIGURING THE INTERFACE
Scan the programming bar code from the following section which selects the appropri
-
ate interface type to match the system the scanner will be connected to. Next, proceed
to the corresponding chapter in this manual (also listed in the table) to configure any
desired settings and features associated with that interface.
NOTE: Unlike some other programming features and options, interface
selections require that you scan only one programming bar code label. DO
NOT scan an ENTER/EXIT bar code prior to scanning an interface selection
bar code. Some interfaces require the scanner to start in the disabled state
when powered up. If additional scanner configuration is desired while in
this state, pull the trigger and hold for 5 seconds. The scanner will change
to a state that allows programming with bar codes.
USB-COM
A
Select USB-COM-STD
USB-COM
$P,HA47.P
USB-Composite
(combines USB-KBD emulation and USB-COM
$P,HA4D.P
Select USB-Composite
a. USB-COM driver needs to be installed for these interfaces to work. Please download it from www.datalogic.com
OTHER INTERFACES
USB HID POS
$P,HA44.P
Select USB HID POS
Select USB Toshiba TEC
USB Toshiba TEC
$P,HA41.P
Datalogic Magellan Scanners'
specific interface, USB AUX
$P,HA40.P
Select Datalogic Magellan Scanners' USB AUX
