Reading Parameters
30
QuickScan™ QBT24XX
Resetting Standard Product Defaults
Reference the PRG for a listing of standard factory settings. If
you aren’t sure what programming options are in your reader,
or you’ve changed some options and want the factory set-
tings restored, scan the
Standard Product Default Settings
bar
code below to copy the factory configuration for the currently
active interface to the current configuration.
Reading Parameters
Point the reader at the target and pull the trigger to enable
the aiming system and the illuminator (red beam) to decode
the barcode label. The aiming system will briefly switch off
during the acquisition time and if no code is decoded will
switch on again before the next acquisition. The illuminator
will remain on until the symbol is decoded.
As you read code symbols, adjust the distance at which you
are holding the reader.
Aiming System
A number of options for customizing control of the Aiming
System are available. See the PRG for more information and
programming bar codes.
Factory defaults are based on the interface
type. Configure the reader for the correct inter-
face before scanning this label.
Standard Product Default Settings
