Datalogic QuickScan i QD2100, Reference Manual

Page: 362 / 388

INDICATION DESCRIPTION LED BEEPER
Power-up Beep
The imager is in the process of
powering-up.
Imager beeps four times at high-
est frequency and volume upon
power-up.
Good Read Beep
A label has been successfully
scanned by the imager.
LED behavior for this indi-
cation is configurable via
the feature “
Good Read:
When to Indicate ”
The imager will beep once at
current frequency, volume,
mono/bi-tonal setting and dura-
tion upon a successful label
scan.
ROM Failure
There is an error in the imager's
software/programming
Flashes
Imager sounds one error beep at
highest volume.
Limited Scanning
Label Read
Indicates that a host connection
is not established when the IBM
or USB interface is enabled.
N/A
Imager 'chirps' six times at the
highest frequency and current
volume.
Imager Active
Mode The imager is active and ready
to scan.
The LED is lit steadily a
a. Except when in sleep mode or when a Good Read LED Duration other than 00 is selected
N/A
Imager

Disabled
The imager has been disabled
by the host. The LED blinks continu-
ously
N/A
Green Spot is on
continuously
While in Stand Mode or Trigger
Object Sense mode the green
spot shall be on while in stand
watch state.
N/A N/A
Green Spot
a
flashes momen-
tarily
Upon successful read of a label,
the software shall turn the green
spot on for the time specified by
the configured value.
N/A N/A

Programming Mode - The following indications ONLY occur when the imager is in Programming Mode.
Label Program-
ming Mode Entry A valid programming label has
been scanned.
LED blinks continuously
Imager sounds four low fre-
quency beeps.
Label Program-
ming Mode
Rejection of Label
A label has been rejected. N/A
Imager sounds three times at
lowest frequency & current vol-
ume.
Label Program-
ming Mode
Acceptance of
Partial Label
In cases where multiple labels
must be scanned to program one
feature, this indication acknowl-
edges each portion as it is suc-
cessfully scanned.
N/A
Imager sounds one short beep
at highest frequency & current
volume.
Label Program-
ming Mode
Acceptance of
Programming Configuration option(s) have
been successfully programmed
via labels and the imager has
exited Programming Mode.
N/A
Imager sounds one high fre-
quency beep and 4 low fre-
quency beeps followed by reset
beeps.
Label Program-
ming Mode Can-
cel Item Entry
Cancel label has been scanned. N/A
Imager sounds two times at low
frequency and current volume.
352 QuickScan
TM
QD2100
LED and Beeper Indications