Enter/Exit Programming Mode
220
PowerScan™ PD953X/PBT950X/PM950X
Date-Time Separator
Sets the character used to separate Date and Time from the next field in
message.
DEFAULT
$CRFTD0000\r
Disable Date-Time Separator
$CRFTD01\r
Set Character Separator =
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 2 digits from the Alphanu-
meric characters in
repre-
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
Summary of Contents for PowerScan 950X Series
