Datalogic Pegaso, Product Reference Manual

Page: 84 / 172

Accessories
A-12 Pegaso™ Industrial PDA with Windows
®
CE
Screen Protector
A Screen Protector is available for the Pegaso. Use the following instructions to attach a
Screen Protector.
1. Gently but thoroughly clean the touchscreen using a lens
cloth or other soft, lint-free cloth. If necessary, dampen
the cloth with a mild cleaning solution, such as liquid
hand soap and water. Thoroughly dry the area after
cleaning, and ensure it is lint-free.
2. Remove the Screen Protector from its packaging
and, while holding it by the edges, pull the tab to
begin peeling the backing from about one inch of
the adhesive side. Fold the backing down as you go.
3. Orient the Screen Protector with its adhesive side towards the screen and CARE-
FULLY align its top edge and corners with the screen recess, as shown in
Figure
A-11 A. If alignment is not perfect, gently lift up and start again.
4. Continue to peel the backing while slowly seating the protector in place. Use a
credit card (if available) or similar soft-edged object to evenly smooth the Screen
Protector and push out any bubbles between the surfaces. Reference Figure
A-11 B.
Figure A-11. Applying a Screen Protector to the Pegaso
You may find it helpful to have the unit firmly seated in its dock while performing these
procedures. Another useful tip is to have a credit card handy to assist in smoothing the
Screen Protector in place.
CAUTION
Never use corrosive or abrasive cleaners or cloths on the
Pegaso.
Tab
CAUTION
DO NOT touch the adhesive area, as this could leave a fingerprint when installed.
A
B