Datalogic Pegaso, Product Reference Manual

Page: 63 / 172

Product Reference Guide 4-1
Chapter 4
Networks, Communications, and
Connections
Overview
This section contains the following topics:
• "Installing & Setting Up Microsoft ActiveSync" starting on page 4-1 .
• "Installing Microsoft ActiveSync" on page 4-1 .
• "Setting up ActiveSync" on page 4-3 .
• "Installing the USB Driver" on page 4-4 .
• "Using ActiveSync" starting on page 4-5 .
• "Networking" starting on page 4-8 .
• "Setting up the Network ID" starting on page 4-8 .
• "Network and Dialup Connections" starting on page 4-8 .
• "Network Setup: Remote ActiveSync" starting on page 4-9 .
• "SNMP" starting on page 4-9 .
Installing & Setting Up Microsoft ActiveSync
This section provides instructions on setting up the Host PC so that the PC can com-
municate with the Pegaso and the dock.
Installing Microsoft ActiveSync
Microsoft
®
ActiveSync is a file transfer tool used to synchronize the files on a PC with
the files on your Pegaso. The device comes from the factory with ActiveSync loaded. If
you have ActiveSync already installed on your PC, make sure that you have v3.7.1 or
higher.
The screen shots in the manual were taken and the procedures were written using Win-
dows
®
XP. If you are using a different Windows operating system, appearances and pro-
cedures may be slightly different.
Important! You must disconnect any other PDAs, PDTs, or Pegasos using USB Active-
Sync from the Host PC prior to connecting the Pegaso or the Host PC and Microsoft
ActiveSync may not recognize the new device.