Datalogic PD9330, Product Reference Manual

Page: 251 / 332

Enter/Exit Programming Mode
Product Reference Guide 241
ADDITIONAL FEATURES FOR 16-KEY MODELS
See also "Function Keys Configuration (16-key models only)" on page 236.
Last Code Shown Timeout
After the CODE transmission, the last code read will be shown on the display
for a configurable timeout (LAST CODE SHOWN TOUT).
The standard DISPLAY OFF TIMEOUT (see
page 228
) has a higher pri-
ority than the LAST CODE SHOWN TOUT, so the two parameters should
be combined to get the desired result.
.
$CDIST
Last Code Shown Timeout
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by 2 digits (00-63 by 01) from the Alphanu-
meric characters in
Appendix D, Keypad.
End by scanning the ENTER/EXIT bar code twice.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
Display Time Stamping Mode
Time Stamping Mode can be applied when entering data from either a bar-
code, from the keyboard, or both.
$CDITS00\r
Applied to both
DEFAULT
$CDITS01\r
Applied only to barcode data
$CDITS02\r
Applied only to keyboard data