Datalogic Modem, Quick Reference

Page: 18 / 82

STAR

Modem™
10
UK/US
SET RADIO ADDRESS
Follow the procedure below to set the STAR

Modem™ radio address and prepare it
to transmit data to the destination device of the system:
1.
Enter Configuration
$+
2.
Set STAR
   
Modem™ Radio Address
xxxx = four digits for the STAR

Modem™ address (from
0000 to 1999 ). This address must be unique.
MA0RCxxxx
3.
Address of the Stand Alone Destination Device
xxxx = four digits for the address of the Stand Alone
Destination Device (from 0000 to 1999 ).
This address must be unique.
MSxxxx
4.
Set RF Baud Rate (not for USA model)
x = 0 defines 9600 baud
1 defines 19200 baud
MFx
5.
Exit and Save Configuration
$-CR
No interface selection is required, since STAR

Modem™ can transmit data only if
connected to the Host via its RS232 serial interface.
STAR
   
Modem™ SETUP FOR STAR-System™ Mode
RESTORE DEFAULT
Whenever necessary, send the following string to STAR

Modem™ via RS232 to
restore its default values:
Restore STAR
   
Modem™ Default
$+$*CR
This command does not change the STAR

Modem™ address nor the
address of the STAR-System™ destination devices, nor the RF Baud Rate
parameters
.