Datalogic Matrix 120, Product Reference Manual

Page: 17 / 188

STEP 1 - CONNECT THE SYSTEM
PRODUCT REFERENCE GUIDE 3
Serial Connections
To connect the system in a Serial point-to-point configuration, you need the hardware
indicated in Figure 3. In this layout the data is transmitted to the Host from the Matrix
120 main serial interface.
Matrix 120 power and I/O device connections take place through the CBX connection
box using the CAB-1011 accessory cable.
When One Shot or Phase Mode Operating mode is used, the reader is activated by an
External Trigger (photoelectric sensor) when the object enters its reading zone.
Host
Main Serial Interface (RS232 or RS422 Full-Duplex)
Optional Outputs
External Trigger (for One Shot or Phase Mode)




CAB-1011
CBX


10-30 Vdc
External Power for Matrix 120
and I/O Accessories
Figure 3 - Serial Point-to-Point Layout
NOTE
For device configuration through DL.CODE, it is recommended to use
either the Ethernet or USB interface (depending on your model). See
USB Connection.
It is not recommended to use the Main Serial interface for configuration
unless the other interfaces are not available.