Datalogic Magellan 9300i, Product Reference Manual

Page: 462 / 520

450 Magellan™ 9300i / 9400i Scanners
Audio Indications
The speaker (beeper) mounted in the scanner’s bonnet will beep or sound other
audio indications to announce scanning, weighing, errors or other functions
(see ). Beep indications specific to Electronic Article Surveillance (EAS) are listed
in the next section.
NOTE
The indications listed below are the factory default settings. Your
scanner may have been configured with different beeper settings.
For example, certain beeper indications may be turned off.
AUDIO
INDICATION
DESCRIPTION OF SOUND COMMENT
Power-up tone
Unique WAV file sound. Synthesized
tones ending with two bell sounds.
Indicates the scanner is powering-on.
Good Read Beep
One beep at current frequency and
volume.
The duration of the beep is also at the current setting.
ROM Failure
One 200ms error beep at low fre-
quency.
Indicates Boot ROM or Program ROM failure.
Chirp

Indications
Six “Chirps” at highest frequency and
current volume.
A “Chirp” is used to indicate the following:
-Reading labels while in limited scanning mode.
-Label rejection during label programming.
-A label with no data.
-Labels rejected through the auxiliary port when in
Scanner Diagnostics Mode.
Bootload Entry

Indications
The beeper sounds a series of beeps
at highest frequency and current vol-
ume to indicate various
See
Error Codes on page 64
in the
Problem
Isolation on page 63
section for more details.
Null Interface
Selected 40 error beeps at highest volume,
20ms ON and 20 ms OFF.
This means that no interface has been selected. Refer
to the
Programming on page 93
section for
interface configuration information.