Datalogic MAGELLAN 8500?, Product Reference Manual

Page: 249 / 456

Product Reference Guide
6-135
UPC-E 128 Supplemental Label ID
This feature specifies a UPC-E 128 Supplemental label ID to be added to
barcode data.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan the barcode, SET UPC-E 128 SUPPLEMENTAL LABEL
ID below. You’ll need to cover any unused barcodes on this and
the facing page to ensure the scanner reads only the barcode you
intend to scan.
3. Scan the appropriate digits from the keypad in
Appendix C
that
represent the desired Label ID characters; entered as two hex
pairs. A table containing the
ASCII Character Set and their corre-
sponding Hex Values is available in the inside back cover of this
manual. ASCII parameters must be input by scanning a pair of
hexadecimal digits for each character. Thus, to set a two-character
value of AB, barcodes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’
must be scanned. The selectable range for this option is any hex
value from 00 to FF.
4. Complete the programming sequence by scanning the SWITCH
barcode.
SET UPC-E 128 SUPPLEMENTAL LABEL ID
NOTE
The programming feature, RS-232 Label ID Control , designates
whether the Label ID is transmitted as a prefix or suffix or if Label ID is dis-
abled.