Datalogic MAGELLAN 3200VSI, Product Reference Manual

Page: 13 / 200

Mount Installation
Product Reference Guide
5
Figure 3. Using the Risers
Wall Mount
Attach the L-Bracket to the wall, securing it in the desired position with two screws through the
two holes in the back face of the L-Bracket as shown in
Figure 2
. Recommendation: Use two Pan
Head (8.2mm or 5/16” maximum head diameter) #8 screw with a thread profile that suits the
mounting surface material in the wall.
Countertop Mount
If using the L-Bracket alone for countertop installation, secure the bracket in place using two
screws through the bottom face of the bracket (see
Figure 2
). If risers are used, secure a riser to
the countertop by attaching two screws through its screw holes. Recommendation: Use two Pan
Head (8.2mm or 5/16” maximum head diameter) #8 screw with a thread profile that suits the
mounting surface material in the countertop.
Risers may be stacked as shown in
Figure 3
b. Each riser increments the height of the mounted
scanner by 1.5” (38.1mm). Riser pieces readily snap together or apart and allow for adjustable
tilt of the scanner/L-Bracket of up to 20 degrees in 5° increments.
Figure 3
b provides an example
of a tilted scanner.
One Riser
Two Risers stacked. Scanner and
L-Bracket have been tilted on the
top Riser.
a b
CAUTION
Do not use a countersink type of screw head. Damage will occur from
use of a countersunk screw head in the plastic screw bosses