Datalogic lynx bt, Reference Manual

Page: 153 / 200

REFERENCES
5
5.5.2 Auto-Connection (For Master Only)
Upon power-up, the Lynx ™ BT reader makes attempts to connect with the remote
Bluetooth
®
device (Slave). If the connection is not successful, the reader remains on,
but not connected.
In this case reconnection can be requested by double clicking the reader trigger or by
reading the "Request Radio Connection" command in par. 5.8.
5.5.3 Auto Reconnection (For Master Only)
If a radio connection is interrupted, the Lynx™ BT reader makes attempts to
reconnect with the remote Bluetooth
®
device (Slave). If the connection is not
successful, the reader remains on, but not connected.
In this case reconnection can be requested by double clicking the reader trigger or by
reading the "Request Radio Connection" command in par. 5.8.
5.5.4 RX Timeout with BT Device
This parameter can be used to automatically end data reception from the remote BT
device (Host) after the specific period of time.
If no character is received from the BT device (Host), after the timeout expires, any
incomplete string (any string not terminated by <CR>) is flushed from the device
buffer.
5.5.5 User-Friendly Name
This parameter provides a way to identify the Lynx™ BT reader in a human readable
(user-friendly), format. This name is returned with the reader configuration
parameters (see par. 5.7). The name is made up of a fixed 50-character field.
The user-friendly name default value is: “
Datalogic BT Device s/n: xxxxxxxxx “,
where x = Lynx™ BT serial number.
5.5.6 Authentication & Encryption with BT Device (for Master
Only)
If enabled, this parameter encrypts the radio communication between the Lynx™ BT
working as Master and the BT device. To start the encrypted communication it is
possible to define an entering PIN code. If it is not set, the default PIN code (1234)
will be used.
133